fbpx

DISCONTINUED

This machine is no longer in production. If you like what you see,  

Refer to the VH2000. It has the same working space and similar specs.

  • The Vapor Hone 1200 is backed by the industry’s best LIFETIME WARRANTY
  • 100% built in the USA
  • American tech support Monday – Friday
  • Right hand side load door
  • One piece molded polymer design
  • LED lighting for better visibilities
  • Boron Carbide blasting gun inserts
  • Foot switch operated for easy process control
  • Support frame is made from 12Ga steel powder coated
  • Machine capable of supporting 500lbs
  • Massive interior work area
  • IP67 wash down industrial controls are mounted to the front of the machine
  • All service connections located on the left side of the machine as pictured
  • Vapor Hone 1200 is a open loop system
  • All equipment service connections are on the back or left side of the machine
  • 1/2″ NPT air connection is needed
  • Perforated floor with internal floor supports to hold up to 500lbs
  • Large door opening for industrial jobs
  • Robust construction and sleek design
  • Excellent wear resistance
  • Built to work as hard as you do

Equipment Specs

Internal Working Dimension 40″ W x 40″ D x 40″ H
Power 110V Single Phase
Abrasive Amount 35 lbs.
Water Amount 25 Gallons
Pump High Volume Slurry Pump
Pump Impeller Standard Plastic Pump Impeller
Gun Tips Boron Carbide Blasting Gun Tips
Compressor Specs 7.5HP or Larger
CFM 20-30 CFM
PSI 60-100 PSI
Assembly No Assembly Required

Optional Features

1.5K Sump heater

Closed Loop rinsing sedimentation tank

Abrasive density meter

Rubber lined walls for abrasion resistance and noise suppression

500 lbs. capacity stainless steel 36″ turntable

Frequently Asked Questions

  1. What’s the regular maintenance on vapor blasters as a whole?
  2. How often do I change media and water?
  3. Can I mix in something to stop freezing in the winter if I don’t have the unit in a place with heating?
  4. What abrasives can I run in the vapor hone?
  5. Does vapor honing take a lot of CFM?
  1. Really just changing the water and abrasive that’s it. Consumables will last much longer in the wet systems due to the cushioning effect.
  2. If you use it every other day I would change every month. If its occasional use you might go 2 – 3 months.
  3. One of the most frequent questions that I don’t have a good solution for other than draining the machine if you know it will be sitting for more than a week in the cold weather. I personally try to minimize mixing any thing other than water and abrasive because it can create bad finishes if it throws out the PH of the slurry.
  4. Any abrasive that you run in a dry blasting cabinet will run in a vapor hone machine.
  5. It depends on what you define as a lot any wet cabinet can need 15 – 45 CFM to operate just depends on what machine model you choose.
If you like to see other machines in action or our before and after results, please visit our YouTube channel and subscribe
Click Below
lifetime warranty
design in USA
SiteLock