Internal Working Dimensions | 36″ W x 30″ D x 38″ H |
Power | 220V Single Phase |
Abrasives Amount | NO ABRASIVE |
Water Amount | 30 Gallons |
Pump | High Volume Pressure Pump |
Compressor | Little CFM Required |
PSI | 1200 PSI at The Gun |
Assembly | No Assembly Required |
- The HB1000 is backed up by the industry’s best LIFETIME WARRANTY
- 100% built in the USA
- American tech support Monday – Friday
- Model is built to last
- Stainless steel
- 2 (2′) LED light bar for better visibility
- One Gun with Fan & Jet Spray Functions
- Dryer hose inside
- E-stop button
- Right-hand side load door
- Wiper included
- Foot pedal control
- Upgrade option w/o depreciation
- A heater comes standard with the HB1000, which aids in the removal of oil, grease, and grime.
- The HB1000 can be used with an aqueous based detergent to aid in grease and grime removal.
- The HB1000 is the ultimate high-pressure parts washer, as it easily removes contaminants from parts. Its 1200 working PSI, coupled with its dual gun settings, makes certain you can find the correct cleaning pattern for your parts.
1. What’s the regular maintenance on vapor blasters as a whole?
2. How often do I change media and water?
3. Can I mix in something to stop freezing in the winter if I don’t have the unit in a place with heating?
4. What abrasives can I run in the vapor hone?
5. Does vapor honing take a lot of CFM?
1. Really just changing the water and abrasive that’s it. Consumables will last much longer in the wet systems due to the cushioning effect.
2. If you use it every other day I would change every month. If its occasional use you might go 2-3 months.
3. One of the most frequent questions that I don’t have a good solution for other than draining the machine if you know it will be sitting for more than a week in the cold weather. I personally try to minimize mixing any thing other than water and abrasive because it can create bad finishes if it throws out the PH of the slurry.
4. Any abrasive that you run in a dry blasting cabinet will run in a vapor hone machine.
5. It depends on what you define as a lot any wet cabinet can need 15-45 CFM to operate just depends on what machine model you choose.