-
Our Vapor Hone 4000 is backed up by the industry’s best LIFETIME WARRANTY
-
100% built in the USA
-
American tech support Monday – Friday
-
The VH4000 is built to last a lifetime
-
The dual station is an optional add on, single work station are standard
-
Large opening doors for easier machine access
-
Left hand side door allows easier part loading or unloading and machine maintenance
-
Door drip pans contain any door leaking and drain back into machine hopper
-
All equipment service connections are on the back of the machine
-
1/2″ NPT air connection is needed
-
VH 4000 is fitted with the optional closed loop filtration system
-
41″ Diameter 1/4″ thick 304 stainless steel supported turntable
-
Machine exterior is painted White
-
Supports up to 1,000 lbs.
-
Folding design of loading system eliminates the need for 15 ft. ceilings since standard doors can be utilized
-
VH 4000 is fully factory tested and assembled
-
Rolling cart assembly seen in picture is optional accessory
| Internal Working Dimension | 60″ W x 48″ D x 38″ H |
| Power | 110V or 220v Single Phase |
| Abrasives Amount | 42lbs. of Abrasive |
| Water Amount | 30 Gallons |
| Pump | High Volume Slurry Pump |
| Gun Tips | Boron Carbide Blasting Gun Tips |
| Compressor Specs | 7.5HP or Larger |
| CFM | 20-30 CFM |
| PSI | 80-90 PSI |
| Assembly | No Assembly Required |
Optional Features
220 V
3K Sump heater
Closed loop rinsing sedimentation tank
Abrasive density meter
Rubber lined walls for abrasion resistance and noise suppression
Track and car system for loading heavy parts
1,000 lbs. capacity stainless steel turntable
If you are looking for the baddest machine on the planet and the best bang for your buck then look no further. I use the machine to re manufacture wheels and it has worked flawlessly since day one startup.
Josh H,
California
If you cant pay cash for this VH4000 then go grab financing you need this size cabinet. No matter what part a customer comes to me with I can handle it. I have a surface preparation business blasting any and all parts. Top notch product and people that back it.
Enzo F,
North Dakota
Company Reviews
Ben Angerstein.
515 Vapor Honing, LLC
Vapor Honing Questions
1. What’s the regular maintenance on vapor blasters as a whole?
2. How often do I change media and water?
3. Can I mix in something to stop freezing in the winter if I don’t have the unit in a place with heating?
4. What abrasives can I run in the vapor hone?
5. Does vapor honing take a lot of CFM?
1. Really just changing the water and abrasive that’s it. Consumables will last much longer in the wet systems due to the cushioning effect.
2. If you use it every other day I would change every month. If its occasional use you might go 2-3 months.
3. One of the most frequent questions that I don’t have a good solution for other than draining the machine if you know it will be sitting for more than a week in the cold weather. I personally try to minimize mixing any thing other than water and abrasive because it can create bad finishes if it throws out the PH of the slurry.
4. Any abrasive that you run in a dry blasting cabinet will run in a vapor hone machine.
5. It depends on what you define as a lot any wet cabinet can need 15-45 CFM to operate just depends on what machine model you choose.
