Internal Dimension | 30″ W x 25″ D x 24″ H |
Power | 110V / 220V Single Phase / Three Phase |
Abrasives Amount | 18lbs. |
Water Amount | 13 Gallons |
Pump | High Volume Slurry Pump |
Pump Impeller | Industrial Polyurethane Pump Impeller |
Gun Tips | Boron Carbide Blasting Gun Tips |
Compressor Specs | 7.5 HP or Larger |
CFM | 20-30 CFM |
PSI | 60-100 PSI |
Assembly | No Assembly Required |
Optional Features
220V
3K Sump Heater
Closed loop rinsing sedimentation tank
Abrasive density meter
Rubber lined walls for abrasion resistance and noise suppression
1,000 lbs. capacity stainless steel turntable
-
The Vapor Hone Ergo 750 is backed by the industry’s best LIFETIME WARRANTY
-
100% Made in the USA
-
American tech support Mon- Fri
-
Industrial machine built to last
-
Right hand side load door
-
LED lighting for better visibility
-
Boron Carbide blasting gun inserts
-
Durable 40 mil thick seamless rubber gloves
-
Safety door interlock switch for higher levels of processing safety
-
2 LED light bars
-
Window rinse and window wiper
-
Top ball valve is your overflow
-
Middle ball valve drains out water only
-
Bottom ball valve drains both water and abrasives
-
This image is an example of a closed loop system
-
Precision air regulator for quick and precise air adjustments
-
Compressed air nozzle
-
1/2″ NPT air connection is needed
-
Full product support and access to our Knowledge base page
-
Foot switch operated blasting gun
-
Fully welded stainless steel forklift slots
-
Machine can be stainless steel or aluminum
-
Fully factory tested and assembled
-
E-stop
-
Density meter optional upgrade for tighter process control
-
All equipment service connections are on the back of the machine
-
Easily monitor the abrasive levels in your machine with the turn of a button
-
Quick adjustment floor supporting system
-
Precision laser cut stainless steel to support weights in excess of 500lbs
-
Drop in supports can be easily adjusted for smaller or larger items
Small industrial foot print built rock solid to last a lifetime. Cant go wrong with the ergonomics of the VH Ergo 750 sit and blast machine.
Harry H,
South Carolina
Buy closed loop if you have the extra cash its worth it.
Jack M,
Georgia
- What’s the regular maintenance on vapor blasters as a whole?
- How often do I change media and water?
- Can I mix in something to stop freezing in the winter if I don’t have the unit in a place with heating?
- What abrasives can I run in the vapor hone?
- Does vapor honing take a lot of CFM?
- Really just changing the water and abrasive that’s it. Consumables will last much longer in the wet systems due to the cushioning effect.
- If you use it every other day I would change every month. If its occasional use you might go 2-3 months.
- One of the most frequent questions that I don’t have a good solution for other than draining the machine if you know it will be sitting for more than a week in the cold weather. I personally try to minimize mixing any thing other than water and abrasive because it can create bad finishes if it throws out the PH of the slurry.
- Any abrasive that you run in a dry blasting cabinet will run in a vapor hone machine.
- It depends on what you define as a lot any wet cabinet can need 15-45 CFM to operate just depends on what machine model you choose.