Gladiator Automated Vapor Hone



Internal Working Dimensions	36″ W x 30″ D x 30″ H
Power	220V Three Phase
Abrasive Amount	40 lbs.
Water Amount	28.5 Gallons
Pump	High Volume Slurry Pump
Pump Impeller	Industrial Polyurethane Pump Impeller
Gun Tips	Boron Carbide Blasting Gun Tips
Compressors Specs	15 HP or Larger
CFM	80 CFM
PSI	100-120 PSI
Assembly	No Assembly Required

The Gladiator Automated Vapor Hone is backed up by the industry’s best LIFETIME WARRANTY
100% built in the USA
American tech support Monday-Friday
Industrial machine built to last a lifetime

Fully Automated Hands Free Blasting
Fully welded stainless steel forklift slots to easily move the machine for servicing
All equipment service connections are on the left and back of the machine
Fully Automated Hands Free Blasting
LED lighting for better visibility
Boron Carbide blasting gun inserts for long lasting performance

3/4″ NPT air connection is needed for hookup and will require your own air connector. We recommend hard plumbing the machine directly into your air source for the least amount of CFM and PSI restriction
All equipment service connections are on the left and back of the machine
Fully welded 304 12Ga Stainless Steel for a lifetime of blasting

PLC controlled process
Load the heaviest of parts with a turntable capable of supporting up to 1000 lbs.
Automated Turntable system with vertical moving blasting guns
Automated Blasting

This machine is fitted with the closed loop filtration system with paper roll for filtering out the smallest of contaminates
Fully PLC controlled built to the highest industrial panel building standards
Comes with crate



What’s the regular maintenance on vapor blasters as a whole?
How often do I change media and water?
Can I mix in something to stop freezing in the winter if I don’t have the unit in a place with heater?
What abrasives can I run in the vapor hone?
Does vapor honing take a lot of CFM?

Really just changing the water and abrasive that’s it. Consumables will last much longer in the wet systems due to the cushioning effect.
If you use it every other day I would change every month. If its occasional use you might go 2-3 months.
One of the most frequent questions that I don’t have a good solution for other than draining the machine if you know it will be sitting for more than a week in the cold weather. I personally try to minimize mixing any thing other than water and abrasive because it can create bad finishes if it throws out the PH of the slurry.
Any abrasive that you run in a dry blasting cabinet will run in a vapor hone machine.
It depends on what you define as a lot any wet cabinet can need 15-45 CFM to operate just depends on what machine model you choose.